H3c-technologies H3C WX6000 Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 171)

11-36

[AC] display nqa history admin test

NQA entry (admin admin, tag test) history record(s):

Index Response Status Time

1 13 Succeeded 2007-11-22 10:27:25.1

UDP Echo Test Configuration Example

Network requirements

As shown in Figure 11-11, configure NQA UDP echo tests to test the round-trip time between AC and

Device. The destination port number is 8000.

Figure 11-11 Network diagram for the UDP echo tests

Configuration procedure

Before you make the configuration, make sure the devices can reach each other.

1) Configure Device

# Enable the NQA server and configure a listening service to listen to IP address 10.2.2.2 and UDP port

8000.

<Device> system-view

[Device] nqa server enable

[Device] nqa server udp-echo 10.2.2.2 8000

2) Configure AC

# Create a UDP echo test group.

<AC> system-view

[AC] nqa entry admin test

[AC-nqa-admin-test] type udp-echo

# Configure UDP packets to use 10.2.2.2 as the destination IP address and port 8000 as the destination

port.

[AC-nqa-admin-test-udp-echo] destination ip 10.2.2.2

[AC-nqa-admin-test-udp-echo] destination port 8000

# Enable the saving of history records.

[AC-nqa-admin-test-udp-echo] history-record enable

[AC-nqa-admin-test-udp-echo] quit

# Start UDP echo tests.

[AC] nqa schedule admin test start-time now lifetime forever

# Stop UDP echo tests after a period of time.

[AC] undo nqa schedule admin test

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 177 178 179

Pas de commentaire

H3c-technologies H3C WX6000 Series Access Controllers Manuel d'utilisateur Page 171