H3c-technologies H3C WX5500E Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 54)

Outputting system information to the SNMP module

The SNMP module receives the trap information only, and discards the log and debugging information.

To monitor device running status, trap information is usually sent to the SNMP NMS. For this purpose, you

must configure output of traps to the SNMP module, and set the trap sending parameters for the SNMP

module. For more information about SNMP, see "Configuring SNMP."

o output system information to the SNMP module:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enable the information center.

info-center enable

Optional.

Enabled by default.

3. Specify a name for a channel

identified by its number.

info-center channel

channel-number name

channel-name

Optional.

See Table 2 for

default channel

names.

4. Configure an output channel

for the SNMP module.

info-center snmp channel

{ channel-number |

channel-name }

Optional.

By default, system information is

output to the SNMP module

through channel 5 (known as

snmpagent).

5. Configure an output rule for

the SNMP module.

info-center source { module-name |

default } channel { channel-number

| channel-name } [trap { level

severity | state state } * ]

Optional.

See "Default output rules of system

informati

on."

6. Configure the timestamp

format.

info-center timestamp { debugging

| log | trap } { boot | date | none }

Optional.

The timestamp format for log, trap

and debugging information is date

by default.

Outputting system information to the Web interface

The Web interface receives log information only, and discards the trap and debugging information.

This feature allows you to control whether to output system information to the Web interface and, if so,

which system information can be output to the Web interface. The Web interface provides search and

sorting functions. You can view system information by clicking corresponding tabs after logging in to the

device through the Web interface.

To output system information to the Web interface:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enable the information center.

info-center enable

Optional.

Enabled by default.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

H3c-technologies H3C WX5500E Series Access Controllers Manuel d'utilisateur Page 54

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs H3c-technologies H3C WX5500E Series Access Controllers