H3c-technologies H3C WX5500E Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 14)

Installation flow

Figure 3 Installation flow

Mounting the device on a workbench

If a standard 19-inch rack is not available, you can place a device on a clean, flat workbench, as follows:

1. Clean the recessed areas on the chassis bottom.

2. Attach the four rubber feet to the recessed areas on the chassis bottom.

3. Place the device on the workbench.

IMPORTANT:

void placin

heavy objects on the device.

Install the device

Install the device to a

19-inch rack

Mount the device to a

workbench

Ground the device

Install a lightning protector

for a network port (optional)

Connect interface

cables

Connect the power cord

Power on the device

Operating

correctly?

Yes

End

Power off the device

Troubleshoot the device

Start

Install the power module

Connect AC power supply

to power strip with lightning

protection (optional)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 58 59

Pas de commentaire

H3c-technologies H3C WX5500E Series Access Controllers Manuel d'utilisateur Page 14