H3c-technologies H3C WX6000 Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 27)

Installing the access controller

CAUTION:

To avoid bodily injury, do not touch any wire, terminal, or part marked with a high-volta

e hazard si

Inspecting the access controller

Follow these steps before installing a WX6103 access controller:

• Make sure that you have read the chapter “Preparing for installation” carefully and the installation

site meets all the requirements.

• Using the packing list supplied with your access controller, inspect the access controller to be sure

that you have all the items listed in the packing list, and verify that the access controller was not

damaged during shipment. If anything is damaged or missing, contact the H3C customer

representative immediately.

• For regulatory compliance and safety information, see the H3C WX6103 Access Controller

Compliance and Safety Manual.

Installation flowchart

Figure 13 Installation flowchart

Start

Connect the

grounding cable

Install the generic

modules

Connect the

power cables

Connect the

interface cables

Cabling and

cable binding

Check the installation

End

On a workbenchOn a cabinet

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 89 90

Pas de commentaire

H3c-technologies H3C WX6000 Series Access Controllers Manuel d'utilisateur Page 27