H3c-technologies H3C WX2500E Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 7)

Warning: Before an ac power cable is either plugged in to or removed from a unit, the ac power

source supplying this cable must be switched off.

Warnung: Bevor ein Wechselstromnetzkabel entweder an eine Einheit angeschlossen oder von

dieser a/jointfilesconvert/1742092/bgezogen wird, muss die Wechselstromquelle, die dieses Kabel speist, ausgeschaltet

werden.

警告：在安装、移动电源线之前，请切断电源。

Warning: Before the power cable is connected, it must be confirmed that the power cord complies

with the requirements of the actual installation (see power cord table)

Warnung: Überprüfen Sie vor dem Anbringen der Zuleitung immer, ob das von Ihnen verwendete

Kabel den Anforderungen entspricht (siehe Netzkabel-Tabelle).

警告：在进行电源线连接前，请确保电源线与实际安装要求一致

(

参考电源线表格

)

。

Warning Power Cord Table:

The power cord set must be approved for the country where it is used.

WARNUNG Netzkabel Tabelle:

Das Netzkabel muss für das Land, in dem es verwendet wird, zugelassen werden.

警告：电源线表格：

电源线组件必须满足使用的国家认证要求。

U.S.A. and

Canada

• The cord set must be UL approved and CSA certified

• The minimum specification for the flexible cord is:

• No. 18 AWG

• Type SV / SVT or SJ / SJT or SPT-2

• 3 conductor.

• The cord set must have a rated current carrying capacity of at least 10A.

• The attachment plug must be an earth-grounding type with a NEMA

5-15P (15A, 125V) or NEMA 6-15P (15A, 250V) configuration

United Kingdom

• The supply plug must comply with BS1363 (3-pin, 13A) and be fitted with

a 5A fuse that complies with BS1362

• The mains cord must <HAR> or <BASEC> marked and be of type

H03VVF3G0.75 (minimum).

Europe

• The supply plug must comply with CEE 7/7 (“SCHUKO”)

• The mains cord must <HAR> or <BASEC> marked and be of type

H05VVF3G0.75 (minimum)

Denmark

• The supply plug must comply with section 107-2-D1, standard DK2-1a or

DK2-5a.

Switzerland

• The supply plug must comply with SEV/ASE 1011

中国

• 电源线组件必须通过 CCC 认证。

• 使用符合 GB1002，额定值为 250V/10A 的单相两级带接地插头

• 电源线最小线径为 0.75mm

The appliance coupler (the connector to the unit and not the connector to the wall plug) must have a

configuration for mating with an EN 60320 / IEC 320 C13 appliance inlet.

Die Gerätesteckvorrichtung (der Anschluss an die Anlage, nicht an den Wandstecker) muss mit einer

Konfiguration nach EN 60320 / IEC 320 C13 versehen.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

H3c-technologies H3C WX2500E Series Access Controllers Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs H3c-technologies H3C WX2500E Series Access Controllers