H3c-technologies H3C WX2500E Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 10)

These products comply with the European Low Voltage Directive 2006/95/EC and EMC Directive

2004/108/EC.

The most up to date copy of the signed EU Declaration of Conformity can be downloaded from:

http://www.h3c.com.cn/Technical_documents

ErP Directive

This product complies with the Directive 2009/125/EC and European Union Commission Regulation

1275/2008.

a) For each condition providing networked standby into which the equipment is switched by the power

management function or similar function:

— the power consumption data in Watt rounded to the first decimal place:

Type of network port

Max power in network standby/sleep mode if

onl

this

ort is used for remote reactivation

1 RJ-45 autosensing 100/1000 WAN port (IEEE

802.3 Type 100BASE-TX, IEEE 802.3u Type

1000BASE-T)

8.45 Watts

4 RJ-45 autosensing 100/1000 LAN ports (IEEE

802.3 Type 100BASE-TX, IEEE 802.3u Type

1000BASE-T)

8.47 Watts

1 SFP WAN port (IEEE 802.3z Type

1000BASE-X-SFP)

8.98 Watts

— the period of time after which the power management function, or a similar function switches the

equipment automatically into the condition providing networked standby: The product goes into Idle

mode immediately after the last packet has passed on the network.

b) the power consumption of the product in networked standby if all wired network ports are

connected and all wireless network ports are activated: 9.84 Watts.

c) guidance on how to activate and deactivate wireless network ports: See Command Reference

Guide at http://www.h3c.com/portal/Technical_Support___Documents/Technical_Documents/

USA regulatory compliance

FCC Part 15

These products have been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

H3c-technologies H3C WX2500E Series Access Controllers Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs H3c-technologies H3C WX2500E Series Access Controllers