H3c-technologies H3C MSR 50 Manuel d'utilisateur télécharger pdf (Page 23)

Task Command

Remarks

View the ACSEI client version. rpm -q acsei-client -i N/A

The rpm commands are Linux commands. For more information, see Linux operating system guides.

Changing the default startup setting for the ACSEI client

The ACSEI client is enabled automatically after it is installed, and by default, the ACSEI client starts up

when the OAP module starts up. You can configure the system to start or not to start the ACSEI client with

the startup of the OAP module through either the CLI or GUI of the Linux operating system.

To change the default startup setting for the ACSEI client at the CLI, use one of the following commands

in the Linux system on the OAP module:

Task Command

Remarks

Configure Linux not to start the ACSEI

client automatically at startup.

chkconfig acseid off

By default, the ACSEI client is

automatically started at startup.

Configure Linux to start the ACSEI

client automatically at startup.

chkconfig acseid on

By default, the ACSEI client is

automatically started at startup.

To change the default startup setting through the GUI:

1. Log in to the Linux system on an OAP module, and then run the setup command in the Linux system.

Figure 3 Setup interface for the ACSEI client default startup

2. Select System services and press the Enter key.

1 2 ... 18 19 20 21 22 23 24 25 26

Pas de commentaire

H3c-technologies H3C MSR 50 Manuel d'utilisateur Page 23