H3c-technologies H3C WX6000 Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 669)

100

101

69-4

z For the configuration of Track-Static Routing collaboration, the specified static route can be an

existent or nonexistent one. For an existent static route, the static route and the specified Track

object are associated directly; for a nonexistent static route, the system creates the static route and

then associates it with the specified Track object.

z The Track object to be associated with the static route can be a nonexistent one. After you use the

track command to create the Track object, the association takes effect.

z If a static route needs route recursion, the associated Track object must monitor the next hop of the

recursive route instead of that of the static route; otherwise, a valid route may be considered

invalid.

z For details of static route configuration, refer to the Static Routing Configuration part in IPv4

Routing in H3C WX6103 Access Controller Switch Interface Board Configuration Guide.

Displaying and Maintaining Track Object(s)

To do… Use the command… Remarks

Display information about the

specified Track object or all Track

objects

display

track

{ track-entry-number

all

}

Available in any view

Track Configuration Example

Static Routing-Track-NQA Collaboration Configuration Example

Network requirements

z The next hop of the static route from access controller (AC) A to Switch is AC B.

z Configure Static Routing-Track-NQA collaboration on AC A to implement real-time monitoring of

the validity of the static route to Switch.

Network diagram

Figure 69-2 Network diagram for Static Routing-Track-NQA collaboration configuration

1 2 ... 664 665 666 667 668 669 670 671 672 673 674 ... 677 678

Commentaires sur ces manuels

Pas de commentaire

H3c-technologies H3C WX6000 Series Access Controllers Manuel d'utilisateur Page 669

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs H3c-technologies H3C WX6000 Series Access Controllers