H3c-technologies H3C WX5500E Series Access Controllers Manuel d'utilisateur télécharger pdf (Page 116)

106

Table 39 Configuration items

Item Descri

tion

Destination IP Address

Set the destination IP address.

Select the IP address type: IPv4/domain name or IPv6, and then enter the

corresponding IP address or domain name in the field according to the IP address

type.

The device does not support IPv6 addresses.

Security Name

Set the security name, which can be an SNMPv1 community name, an SNMPv2c

community name, or an SNMPv3 user name.

UDP Port

Set UDP port number.

IMPORTANT:

The default port number is 162, which is the SNMP-specified port used for receiving

traps on the NMS. Generally (such as using IMC or MIB Browser as the NMS), you can

use the default port number. To change this parameter to another value, you need to

make sure that the configuration is the same with that on the NMS.

Security Model

Select the security model, that is, the SNMP version. Make sure that the SNMP

version is the same with that on the NMS; otherwise, the NMS cannot receive any

trap.

Security Level

Set the authentication and privacy mode for SNMP traps when the security model is

selected as v3. The available security levels are: no authentication no privacy,

authentication but no privacy, and authentication and privacy.

When the security model is selected as v1 or v2c, the security level is no

authentication no privacy, and cannot be modified.

Displaying SNMP packet statistics

From the navigation tree, select Device > SNMP.

The page for displaying SNMP packet statistics appears.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 253 254

Pas de commentaire

H3c-technologies H3C WX5500E Series Access Controllers Manuel d'utilisateur Page 116