H3c-technologies H3C S3100V2 Series Switches Manuel d'utilisateur Page 57

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 111
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 56
49
The output shows that Ethernet 1/0/3 on Switch B has joined 224.1.1.1 but not 224.1.1.2.
Assume that Source 2 starts sending multicast traffic to 224.1.1.1. Use the display multicast
forwarding-table to display the multicast forwarding table information.
# Display the information about 224.1.1.1 in the multicast forwarding table on Switch A.
[SwitchA] display multicast forwarding-table 224.1.1.1
Multicast Forwarding Table
Total 1 entry
Total 1 entry matched
00001. (1.1.1.1, 224.1.1.1)
MID: 0, Flags: 0x0:0
Uptime: 00:08:32, Timeout in: 00:03:26
Incoming interface: Vlan-interface101
List of 1 outgoing interfaces:
1: Vlan-interface104
Matched 19648 packets(20512512 bytes), Wrong If 0 packets
Forwarded 19648 packets(20512512 bytes)
The output shows that Switch A maintains a multicast forwarding entry for multicast packets from Source
1 to 224.1.1.1. No forwarding entry exists to forward packets from Source 2 to 224.1.1.1, which indicates
that multicast packets from Source 2 are blocked.
Troubleshooting IGMP snooping configuration
Switch fails in layer 2 multicast forwarding
Symptom
A switch fails to implement Layer 2 multicast forwarding.
Analysis
IGMP snooping is not enabled.
Solution
1. Enter the display current-configuration command to view the running status of IGMP snooping.
2. If IGMP snooping is not enabled, use the igmp-snooping command to enable IGMP snooping
globally, and then use igmp-snooping enable command to enable IGMP snooping in VLAN view.
3. If IGMP snooping is disabled only for the corresponding VLAN, just use the igmp-snooping enable
command in VLAN view to enable IGMP snooping in the corresponding VLAN.
Configured multicast group policy fails to take effect
Symptom
Although a multicast group policy has been configured to allow hosts to join specific multicast groups, the
hosts can still receive multicast data addressed to other multicast groups.
Vue de la page 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 110 111

Commentaires sur ces manuels

Pas de commentaire