H3c-technologies H3C MSR 3600 Manuel d'utilisateur télécharger pdf (Page 55)

Replacement procedure

IMPORTANT:

• The barcode on the router chassis contains product information that must be provided to local sales

agent when you return a faulty router for service.

• Keep the tamper-proof seal on a mountin

screw on the chassis cover intact, and if you want to open the

chassis, contact H3C for permission. Otherwise, H3C shall not be liable for any consequence.

Replacing a power module

Power modules are hot swappable.

The replacement procedure of an AC power module and a DC power module is the same. This section

uses an AC power module on the MSR 36-40/36-60 router as an example.

To replace a power module:

1. Locate the power module to be removed and use a Phillips screwdriver to completely loosen the

captive screws of the power module.

2. Holding the handle of the power module with one hand and supporting the bottom of the power

module with the other hand, gently pull the power module out of the slot along the slide rails.

Put the removed power module on an antistatic workbench or into an antistatic bag.

Figure 64 Pulling a power module out of the slot

3. Install a new power module. For the installation procedure, see "Installing the router."

Install a filler panel if you do not install a new power module.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 94 95

Pas de commentaire

H3c-technologies H3C MSR 3600 Manuel d'utilisateur Page 55